electronics questions

[Tazzy Devil 18]

Have a couple of questions regarding electronics. I've just uninstalled a b and G H2000 system and replaced with NMEA 2000 Tritons and Vulcans. I went to a 2k wind setup and heading sensors but to avoid a a haul out ran the B and G analogue Speed and depth transducers (2 seperate transducers) through a DST-2 to convert to 0183 and then AT10 to 2K.

 

The depth works fine but I can only set offsets in display, no biggie. The tritons are refusing to calibrate speed, and there is no in display option.

 

So questions: Is there a trick I'm missing?

 

or:

 

Is there a speed only 2k option that will fit in the housing? 

 

In the frantic dash to get her sorted for Coastal Classic so would appreciate any advice!

[Crazyhorse 47]

Sounds like a "sentence" issue. You might try looking in setup and see if there are settings for different instruments? I am assuming the H2000 is not looking for 0183 but 2K?

[Tazzy Devil 18]

Nah, it's definitely all coming through,I think the Triton can only calibrate smart transducers, there's processor on the network now. I'm hoping there's a way to calibrate in display but if not it's try to find a retrofit smart insert. If not that it's a bloody haul and fit a new TDX.

[Island Time 1,235]

Yep, the Triton will only calibrate n2k transducers. Change to a dst800. I can check the dia later in the week when I'm home, but iirc it fits. Call Navico and ask if you need it sooner.

[Tazzy Devil 18]

Thanks,! DST 800 is too wide. The current tdx is a st850 speed -h. According to air mar the 2k st850 will retrofit. Unfortunately they are not all that common. I’ve ordered one, just hope it arrives in a timely fashion.