Jump to content

Recommended Posts

6 hours ago, Black Panther said:

Kits hull only $5000 Nz plus shipping plus build hours makes for a expensive 11ft dink.

Russel B would not see much of  return on releasing a cnc cut file with the risk of plagiarism etc.

Link to post
Share on other sites
20 minutes ago, Clipper said:

that's a nice looking dinghy

very nice looking dinghy. ugly rig, not as slippery under sail I'm sure, but looks like could carry more people and gear .

Considering The PT11 complete kit including rig rudder centreboard etc is $7500 Kiwi Roubles plus shipping plus build sourcing a nicer rig for the Journeyman locally could be a coin saver.

I’ll send them an enquiry and see if they would consider selling a cnc cut file into the home of the Cup but not for to much longer.

Link to post
Share on other sites
39 minutes ago, Psyche said:

Ply dinghies are not so hard to build, CNC kits only save time (which may be valuable) but with a bit of care and a few tools anyone can measure and cut well enough for epoxy glue.

yup, I've built a couple now, one measured and cut by hand, one CNC'd.  Would only CNC going forward.  

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...