w44vi
Members-
Content Count
765 -
Joined
-
Last visited
Content Type
Profiles
Media Demo
Forums
Gallery
Calendar
Store
Everything posted by w44vi
-
Looks good what paint system did you use?
-
Better to ask forgiveness than permission
-
Scraping is the best to remove the bulk, I have then used acetone to remove the residue, but it will depend on exactly what has been used
-
I have Warpaint over Alex No.5, Its been on for 3yrs, due for replacement, I've had no problems still working ok
-
Put in a non return fuel valve.
-
First thing I would have done is put in a new fuel filter, If that is cloged it creates a vacum and could allow air in to the system
-
My understanding is it is not ready for public service until end of February
-
STOLEN Yacht - Scarlet Dancer. Lotus 9.2. Taken sometime between Tuesday 4pm 14 December and Friday 17 December from her mooring at Anakiwa, Grove Arm, Queen Charlotte Sound. Gary Lokum 0276314450 anytime.
-
about 725-750 KG
-
Further woes - removing an engine via companionway and boom
w44vi replied to aardvarkash10's topic in TechTalk
I have used a hiab truck to remove boat motors, make life much easier -
I put a steel rod thru the pin holes so you can pull aganst each other, when you put the hub back on make sure you put a good amout of marine grease on the spline
-
Do they sell it in 20kg containers ?
-
From the Trade Me ad "The water tight integrity is somewhat compromised due to the (localised) areas of erosion & resultant water ingress There was a towel/rag pushed in to a hull breach at waterline. The port side appeared to have more areas of potential diminished (watertight) integrity, however there was a similar occurrences on both sides." It would take enormous amounts of money to make the hull water tight. The Detroit hasn't run for many years (decades) and the steel superstructure is so rusty you can see thru it. The harbour master has said that they would not let
-
Trio rescued, but family dog dies in Wellington Harbour capsizing
w44vi replied to ex Elly's topic in MarineTalk
I guess they left the bung out ? -
How well does the prop speed work on the sail drive ?
-
Should stop you guys getting cold when eating your roast dinner in next years 24 hr race
-
You could also try you local wreckers or mechanic for an old cast Iron engine block they work well
-
I have in mine the fuel / oil filter numbers, impeller numbers oil grade and quantity for engine and sail drive
-
Sounds like a head gaskit , but could be in the heat exchanger too based of you coment about the reduced flow from the raw water flow
-
Aleana are you using copper based anti foul next to your sail drive ?
-
They were built to a standard not a price
-
Yes there are a few of us on here
-
I use lanolin seems to work ok, it is easy to remove the paddle wheel and can be re apply in the water too
-
If your after weight reduction with your battery go lithium ion. Depending on how big your motor is you maybe able to use a motor cycle battery