sources of boat building foam?

[erice 732]

need to half fill a long old low aspect daggerboard slot - wide, short dagger

 

to fit a high aspect board - narrow,, long dagger

 

need to make up a 66cm x 22cm x 4.5cm block to fill front of daggerwell and act as a  crush block

 

would is it best to get this stuff in ak?

 

 

[Ed 143]

Gruit manufacture corecell, they are up on the north shore somewhere

[erice 732]

thanks 

 

Address: 11 John Glenn Ave, Rosedale, Rosedale, Auckland 0632

Hours: 

Open today · 9AM–5PM

                           

 

Phone: 09-415 6262

 

looks like corecell-M may be the way to go but for my application it probably doesn't matter which foam is used

 

The hull bottom is built with 100kg structural foam, cut into strips onsite and handlaid with epoxy resin. Hi-Panels were used for the topsides, deck and internal structure, with the majority being Corecell M-Foam/glass fibre sandwich panels, infused with Prime 20 epoxy resin.

 

http://www.engineeringnews.co.nz/content/hi-panels-takes-the-strain-out-of-boat-building/