Jump to content

Bed It Tape

Recommended Posts

OK, I've finally been able to source and have in stock the original Bed It Tape, for bedding deck fittings. The first shipment (18 rolls, that's a case) arrived today, so ex stock in NZ for the 1st time. $50 + GST per roll - it's 15m long, 13mm wide and 1,6 thick. This is all I use now and it's awesome!

Link is here https://www.neptunes-gear.com/product/marine-bedding-tape/

Link to post
Share on other sites
1 hour ago, Clipper said:

Cool. Just ordered a roll. Ive heard great things - any advice on how to use?


Full Instructions are here https://marinehowto.com/bed-it-tape/ but basically clean the area to be used, and put it on the surface. Bolt/screw down the hardware and trim of the excess that squeezes out. You may have to do the trim bit again a few weeks later. That's it - as bolted down, it squeezes out and seals around fastenings, although I tend to put some around the top of bolts and countersinks as well.  

  • Upvote 1
Link to post
Share on other sites

Bed-it is one product that lives up to the hype.  
The only thing you have to be careful about is using solvents around it...if you have penchant for walking round your deck with a turps laden rag cleaning this 'n that, just be careful around fittings that have Bed-it.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...