jonathan

my one is 26V open

and what do you prep and fill with under water based?

I want to paint the deck on my hans christian 38, lots of teak so not that much deck.... I want to use a non solvent water based polyurethane. But i want a high gloss white finish, will be mainly brushed. What brand? I like the look of the altex elite but don't really want the solvent hassles is it worth it, can you get same finish with water based.

what do you put as your home port?

So my charger (via gen-set) charges the current AGM at 49Amps dead flat, if i put the a 180ah into the boat it would meet the initial C10 33% 50amp charge, did anyone establish what happens if you go below this?

Firefly got my attention https://youtu.be/PrhapRFkt7o

ok if I wanted to build a carbon fibre sphere, say about 800mm diameter, lets say I had a mould (1/2 sphere....) how much would it cost to make each one in materials... doesnt have to take much load, for the inside of a custom globe.... question 2 , what would be best material for the mould???

great result, damn lucky

also from those who have ac systems onboard.... how much did your eWof cost you? I am a 120V boat, I feed 240 into a full isolating step down transformer then into the boat via a decent system, from there charge 12V run fridges etc etc...

I only have an immediate need for 3rd party but if reasonable would consider a bigger policy... will try baileys now

hi, I normally berth on piles in Tamaki river, but have been offered a berth at Westhaven for a while, I need insurance, I don't want to get a full survey done etc, what are my options, feel free to ring me on 021 380 611 Peter 1982 Hans Christian 38 yacht Looking for a eWof person as well

isn't most 4 stroke lawn mower oil 10 30

I have been on piles in Panmure for 8 years, you get very used to no shore power, just go solar Sad for the racing boats that need a dehumidifier tho, feel better about leaving westhaven now

i would remove the secondary filter (after lift pump and put another in.... just in case seals not good, not much to those seals, any diesel on engine around injector pump?

thinking a go pro it was not safe