Jump to content

This Weekend's Achievements


Guest

Recommended Posts

I've used rope gizmos instead of bolting/screwing saddles and the likes to the deck. Took around 5-6 ice cream containers of metal fittings off, put about 1 back on.

 

I've gone as simple as I can on the keyboard which is now just a row of clam cleats. Out to each side in front of the winches is a triple Easy-Loc rope jammer for high load strings like halyards, tackline and those things.

 

Constrictors are nice but fussy on rope size, fussy on set up and pricey. A standard jammer gives way more flexibility.

 

 

Thank you for advise. This is similar to what I've been thinking just unsure if kite halyards should be central as before or if they'd be better on sides with other halyards. Upside of side is better alignment with a winch but central they could reach each winch which may be better as i only run two winches at the moment. Just took off self tacker so unsure how it will all work in practice. 

 

Will your boat be living at Westhaven? 

Link to post
Share on other sites

Thank you for advise. This is similar to what I've been thinking just unsure if kite halyards should be central as before or if they'd be better on sides with other halyards. Upside of side is better alignment with a winch but central they could reach each winch which may be better as i only run two winches at the moment. Just took off self tacker so unsure how it will all work in practice.

My 3/4 kite halyard runs to a jammer in front of a winch so it can be cranked if the crew is too slow. The masthead halyard the goes to a centreline cleat. It has no need for a winch as it won't get the loads the 3/4 will. With a kite off to one side shouldn't be much worry. 

 

You took the self-taker off??? I can't understand what there is to gain by doing that, if anything I see that as a large negative. I have maximum now that don't use the ST track but when solo the self tacker is a dream and it has won me a few races.

 

 

Will your boat be living at Westhaven? 

Never. It would cause to many issues with the police.

Link to post
Share on other sites

put my new (to me) winches on! was initially happy but after sailing Westhaven to Waiheke on them I felt like the self-tailers were in the wrong position, so I shuffled them around. in doing so I over-tightened them onto the base so the drums weren't turning smoothly, and then sheared the head off a bolt off while adjusting them again to allow room for the drums.

 

so, that was fun.

 

fixed it all up now and relatively happy. they're a little bit big for the boat (beggars can't be choosers when you find a pair of winches for $150 at the car boot sale) so I need bigger sheets if I want to really confidently use the self-tailers in big winds. happy enough with them in under 15kts though.

 

what I can't figure out is why the to-do list doesn't ever get any shorter... :D

  • Upvote 1
Link to post
Share on other sites

Good stuff. Wheres the boat?

In the waterways. Look left as you head out of town at the Kupe st roundabout and you will see a Lotus 9.2 with a scoop added to the transom. Was in Melbourne last weekend but it sounds like the local fleet had a fair bit of breeze for the regatta.

Link to post
Share on other sites

Finally managed to drop tools and get away to barrier.

First sail there in Pukka so rather special.

but to-do gets longer.

Champagne sailing from North head to Tryphena on Sunday surfing thru Colville to 11knts.

5.5hrs from north head, so pretty reasonable av. of 7.6knts.

The Cove is a stunner as we had never been there. Its all stunning especially at this time of

year without all and sundry.

Pod of dolphins entertained on the way back....special! 

Not one work up  all the way round; pretty sad state of affairs.

Must limit their number somewhat.

An indictment on our poor management.

  • Upvote 1
Link to post
Share on other sites

Decided I didn’t like the location of a certain rock to the south of Rangi Light during a single handed race a while back, so shifted it a bit.

Seeing as how Murray Ross was renowned for designing overbuilt heavy shitters I continued to sail it for a month with the kids on board before finally deciding to pull her out and have a look. What followed was three weeks on the hard whilst the good folk at Brin Wilson’s removed and reattached the dangly bit and I took the opportunity to scrape 20 years worth of Antifoul back to the Gelcoat and start the underbelly process properly.

Even with all the gear on, old Antifoul shards make a great chemical peel, so my face now has taken in a youthful appearance whilst my relationship with the wife and the bank account have aged badly.

I gave the rudder a bit more balance while I was at it and the results have been pleasing despite the thing weighing at least 50kg.

Funny side note- since relaunching the depth sounder has stopped working ????

2D3A73D4-2FBD-4053-87C8-838BC0FAFF53.jpeg

CEC95391-0474-493A-8FF0-094DF89D64A5.jpeg

36FFB319-8320-45F5-829E-7A665A19A496.jpeg

A735DBDB-7F1B-45EF-8FDE-1AB16B529BC7.jpeg

D2095DB4-2B7B-4393-A5B2-878318AD3C0E.jpeg

07B32FC4-1695-4C96-81F8-D53D0B5F6318.jpeg

FA0F9317-9AAE-4E66-ACE3-4DC9F9D90CE9.jpeg

69F62813-542C-4A76-848C-A7AF5FB5693C.jpeg

71121799-C594-46DA-AB64-A86CB8E89F02.jpeg

AF058219-98F0-4B84-802C-6B8536705D42.jpeg

A79B89AE-89A8-4F9E-A92A-577B9C5F47D8.jpeg

B7B3227A-B8CB-4AB0-B019-6E2925BCB4AA.jpeg

ACAA1478-1D5E-43F7-9B75-17C851317B6B.jpeg

  • Upvote 1
Link to post
Share on other sites

Boy you gave it a decent thump. Interesting keel on her, bit thinner and shorter on the cord and slightly deeper to mine when we hauled out at the same time. From memory rudder came from another 930. Beut job on the antifoul removal.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...